Description

When your disc bedder or hipper starts making noise or the discs aren’t spinning like they should, it’s usually the bearings telling you they need attention. These bearings take a beating in dusty, muddy conditions and eventually wear out. This Timken replacement bearing gets your equipment back to smooth operation so you can get back to preparing your seedbeds or building rows.

What You’re Getting

Factory-sealed design keeps dirt and moisture out while holding the grease in
Square bore design fits precisely on the disc gang shafts
80mm outer diameter with 1-1/8 inch inner dimension for a snug fit
Timken quality construction that handles the vibration and side loads from field work
Direct replacement for worn bearings – no modifications needed

Built for Real Farm Work

This bearing is designed for disc equipment like John Deere and KMC hippers, as well as various disc bedders and rippers. Whether you’re building potato beds, hipping corn, or working up ground for planting, this bearing handles the constant spinning and side pressure that comes with disc work in tough field conditions.

Made to Last

Timken bearings are built for agricultural applications where dust, dirt, and moisture are constant challenges. The sealed design means you don’t have to worry about greasing – the bearing comes pre-lubricated and stays that way. The hardened steel construction handles impact loads when you hit rocks or hard ground.

Good to Know

Installation is straightforward – just press the old bearing out and press the new one in. Make sure the square bore aligns properly with the shaft, and check that the bearing housing isn’t damaged or worn. Some equipment uses two of these bearings per disc assembly, so you might want to replace both while you’ve got things apart.