Description

If you’re noticing coolant seepage around the water pump cover or finding puddles under your TM series tractor, chances are this little O-ring has called it quits. It might seem like a small part, but when it fails, it can leave you stranded with an overheated engine. This replacement O-ring seals the water pump cover properly so you can get back to work without worrying about coolant loss.

What You’re Getting

Proper seal that keeps coolant where it belongs – in the cooling system
Quality rubber compound that handles temperature swings and chemical exposure
Exact fit for your tractor’s water pump cover – no modifications needed
Inexpensive fix that prevents expensive engine damage from overheating

Built for Real Farm Work

These O-rings fit Ford New Holland tractors from the powerful TM series machines down to the reliable 60 series models. Whether you’re running a TM165 pulling heavy tillage equipment or using an 8160 for loader work around the farmyard, proper cooling system sealing is critical for keeping these hardworking engines running strong.

Made to Last

Farm tractors run hot and work hard, so cooling system seals need to handle constant heat cycles and pressure changes. This O-ring is made from quality rubber that stays flexible even after years of engine bay heat and coolant exposure. It maintains its seal through temperature extremes and the vibration of heavy field work.

Good to Know

Installation is straightforward – drain the coolant, remove the pump cover, and replace the old O-ring with this new one. Clean the sealing surfaces thoroughly and check for any nicks or scratches that could cause leaks. While you’re at it, inspect your coolant condition – contaminated coolant can cause premature seal failure.