Description

If you’ve been running a rotary cutter for any length of time, you know that tail wheel takes a beating. It’s constantly rolling over stumps, rocks, and uneven ground while keeping your cutter deck at the right height. When that wheel starts wobbling or the hub gets loose, your cut quality suffers and you risk tearing up your equipment. This complete assembly gets you back to cutting clean and even.

What You’re Getting

Complete ready-to-install assembly with 4×8 tire, fabricated hub, and heavy-duty fork
1-inch axle pin fits most standard rotary cutter applications
Fabricated hub design provides strength where you need it most
Top pin measures 1-1/2 inches with 6-3/4 inches of usable length for secure mounting
Includes bushings for smooth operation and long service life

Built for Real Farm Work

This assembly is designed for rotary cutters used in pasture maintenance, roadside mowing, and brush cutting operations. The 4×8 tire size gives you good ground contact without being too heavy, while the fabricated hub construction handles the constant flexing and impact that comes with cutting rough terrain.

Made to Last

The fabricated hub design uses welded steel construction that’s stronger than cast alternatives, especially when you’re dealing with side loads from uneven ground. The included bushings reduce wear on the pin and keep everything running smooth, even after hours of bouncing through the field.

Good to Know

This is a direct replacement that mounts with standard hardware. Make sure to grease the bushings regularly—a little maintenance goes a long way in extending the life of the assembly. If you’re replacing just the wheel due to damage, check that the fork isn’t bent before installing the new unit.