Description

If you’ve got a Series 6 PTO driveline that needs a solid implement connection, you know how important it is to have a yoke that clamps securely and won’t let you down when you’re in the middle of a critical job. This clamp-type implement yoke is built specifically for Bondioli Series 6 and Walterscheid 220 applications, giving you that positive grip on a 1-3/4 inch, 20 spline implement shaft that won’t slip or work loose under load.

What You’re Getting

Clamp-style design that grips securely without permanent mounting – perfect for equipment swaps
Precision-machined 1-3/4 inch bore with 20 splines for exact fit on implement input shafts
Heavy-duty construction handles the torque and vibration of real field work
Compatible with both Bondioli Series 6 and Walterscheid 220 metric PTO systems
Quality Weasler manufacturing means reliable service season after season

Built for Real Farm Work

This yoke fits right into the mid-range PTO applications where you need more beef than a Series 5 but don’t need the heavy-duty capacity of a Series 7 or 8. It’s perfect for those 40-80 horsepower tractors running implements like smaller rotary cutters, tedders, rakes, and other PTO equipment where reliable power transfer is critical. The 1-3/4 inch splined connection is common on many implement gearboxes and gives you a positive drive that handles reversing loads and varying speeds without slipping.

Made to Last

Weasler doesn’t mess around with PTO components – their yokes are forged tough and machined to tight tolerances. The clamp design means you get full 360-degree contact around the splined shaft, distributing loads evenly and preventing the concentrated wear you get with bolt-through connections. The bearing surfaces are precision-ground and the cross assembly is built to handle the constant speed changes and angles that come with real field work.

Installation Notes

The clamp style makes this yoke easy to install and remove – just slide it onto your implement’s splined shaft and tighten the clamp bolts evenly. Make sure your implement shaft is clean and free of burrs before installation. The 4.72 inch center-to-end measurement needs to work with your driveline setup, so double-check your shaft length calculations before ordering.