Description
When you’re working on hydraulic cylinders, replacing bushings, or removing stuck pins from implements, you need a punch that’ll get the job done without bending or breaking on you. This 8-inch pin punch gives you the reach and leverage to drive out stubborn pins in deep assemblies, whether you’re fixing a loader, working on your three-point hitch, or rebuilding that cultivator that’s seen too many rocks.
What You’re Getting
- 3/16-inch tip fits most common pin sizes on tractors and implements
- Extra-long 8-inch length reaches into deep assemblies without having to tear everything apart
- Black oxide finish resists corrosion and won’t chip off like paint
- 3-1/2 inch pin length gives you plenty of striking surface for your hammer
- Professional Mayhew quality that holds up to farm shop abuse
Built for Real Farm Work
This punch is sized for the kinds of pins you’ll find throughout your equipment – hydraulic cylinder pins, three-point hitch connections, loader pivot points, and all those places where pins get stuck from years of dirt, grease, and hard use. The long design means you can reach pins in tight spots without disassembling half the machine just to get at them.
Made to Last
Farm work is tough on tools, and this Mayhew punch is built to take it. The black oxide finish not only looks professional but provides corrosion resistance for tools that might sit in a damp shop for months between uses. The steel construction can handle the shock of hammer blows and won’t bend or mushroom like cheaper punches.
Good to Know
Always use a punch that’s slightly smaller than the pin you’re removing – this 3/16-inch size works well for pins up to about 1/4 inch. Start with light taps to get the pin moving, then increase force gradually. Keep the punch square to the pin to avoid binding, and clean the pin holes before installing new pins to prevent future stuck situations.
Reviews
There are no reviews yet.