Ball Bearing for Roll-A-Cone Marker and Agricultural Equipment

Description

When your roll-a-cone marker starts squealing or the cone wobbles instead of rolling smooth, it’s time to replace those worn bearings. This 1-inch bore bearing with triple lip seals keeps your marker running true so you get consistent furrows and straight lines in the field. Nothing worse than crooked rows when you’re trying to make a good impression on the neighbors.

What You’re Getting

• Triple lip seals keep dirt and debris out while holding the grease in where it belongs
• 1-inch inner diameter fits standard roll-a-cone marker shafts perfectly
• 2.05-inch outer diameter and 15mm width for a solid, stable fit
• Pre-sealed construction means no daily greasing or maintenance headaches

Built for Real Farm Work

This bearing is designed for the demanding conditions of field marking and agricultural equipment. Whether you’re laying out waterways, marking strips for planting, or setting up guidance lines, this bearing handles the constant rolling motion and dirt exposure that comes with the territory.

Made to Last

Farm bearings take a beating from dust, moisture, and the bumps that come with uneven ground. The triple seal design provides extra protection against contamination, and the quality construction holds up to season after season of use without breaking down.

Good to Know

This is a direct replacement that installs just like the original. Clean the bearing housing thoroughly before installation and make sure the seals seat properly to get maximum life out of the new bearing. If you’re replacing one, it’s usually smart to do both sides while you’ve got everything apart.