Hydraulic Filter for JCB, John Deere, Komatsu, and Ingersoll-Rand Equipment
Sale!

Hydraulic Filter for JCB, John Deere, Komatsu, and Ingersoll-Rand Equipment

Original price was: $84.11.Current price is: $25.23.

SKU: SMA-BT8841MPG Category:

Description

When your hydraulic system starts running sluggish or you notice the loader response isn’t what it used to be, there’s a good chance your hydraulic filter is doing its job—maybe too well. A clogged filter means it’s been catching all the dirt and debris that would otherwise tear up your expensive pumps and valves. This Baldwin replacement gets your system flowing clean again and protects those costly hydraulic components.

What You’re Getting

  • High-capacity design with 6 3/32-inch length and 3 3/4-inch diameter for maximum dirt-holding ability
  • 1000 PSI minimum burst rating handles the high-pressure demands of modern hydraulic systems
  • 1 3/8-12 thread size matches factory specifications for secure mounting
  • Quality Baldwin construction that’s been protecting hydraulic systems for decades
  • Direct spin-on replacement—no modifications or special tools needed

Built for Heavy-Duty Work

This filter works across a range of equipment including JCB excavators and loaders, John Deere construction and agricultural machines, Komatsu earthmoving equipment, and Ingersoll-Rand compressors. Whether you’re digging foundations, moving materials, or running hydraulic implements, this filter handles the demanding duty cycles that come with commercial and agricultural applications.

Made to Last

The filter media handles the temperature swings and pressure changes that come with real farm work, capturing both fine particles and larger debris that could damage your hydraulic system. The robust construction stands up to vibration and the constant pressure fluctuations of hydraulic systems working under load.

Installation Notes

Standard spin-on installation takes just a few minutes—drain the old filter, clean the mounting surface, and hand-tighten the new filter three-quarters turn after the gasket contacts the base. Change filters every 500-1000 hours depending on your operating conditions—more often if you’re working in dusty environments or doing heavy hydraulic work. Always check your old filter for unusual contamination that might point to other system issues.

Reviews

There are no reviews yet.

Be the first to review “Hydraulic Filter for JCB, John Deere, Komatsu, and Ingersoll-Rand Equipment”

Your email address will not be published. Required fields are marked *